Dlp-H48 Provision A Firewall Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
•
•
Click OK.
Step 4
Continue with your originating procedure (NTP).
Step 5

DLP-H48 Provision a Firewall Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If the SOCKS proxy server is configured as proxy-only or is disabled, you cannot set up a firewall tunnel.
Note
Click the Provisioning > Network > Firewall subtabs.
Step 1
Click Create.
Step 2
In the Create Tunnel dialog box, complete the following:
Step 3
•
•
•
•
Click OK.
Step 4
Continue with your originating procedure (NTP).
Step 5
78-19416-01
Destination Address—Type the IP address of the destination node (32 bit length) or destination
subnet (any other length).
Destination Length—Choose the length of the destination subnet mask.
This task provisions destinations that will not be blocked by the firewall.
Firewall tunnels are only necessary when the SOCKS proxy server is
enabled and a foreign DCC termination exists, or if static routes exist so
that the DCC network is used to access remote networks or devices. You
can provision a maximum of 12 firewall tunnels.
None
DLP-H29 Log into CTC, page 16-43
DLP-H52 Provision Section DCC Terminations, page 16-68
DLP-H40 Create a Static Route, page 16-55
As needed
Onsite or remote
Superuser only
Source Address—Type the IP address of the source node (32-bit length) or source subnet (any other
length).
Source Length—Choose the length of the source subnet mask.
Destination Address—Type the IP address of the destination node (32 bit length) or destination
subnet (any other length).
Destination Length—Choose the length of the destination subnet mask.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
or
16-65