Dlp-H226 Set Up Snmp For An Ene; Figure - Cisco ONS 15310-MA SDH Procedure Manual

Hide thumbs Also See for ONS 15310-MA SDH:
Table of Contents

Advertisement

Click OK. The node IP address of the node where you provisioned the new trap destination appears in
Step 4
the Trap Destinations area.
Click the node IP address in the Trap Destinations area. Verify the SNMP information that appears in
Step 5
the Selected Destination list.
If you want the SNMP agent to accept SNMP SET requests on certain MIBs, click the Allow SNMP Sets
Step 6
check box. If the box is not checked, SET requests are rejected.
If you want to set up the SNMP proxy feature to allow network management, message reporting, and
Step 7
performance statistic retrieval across ONS firewalls, click the Enable SNMP Proxy check box on the
SNMP tab.
The ONS firewall proxy feature only operates on nodes running releases 4.6 and later. Using this
Note
information effectively breaches the ONS firewall to exchange management information.
Note
For more information about the SNMP proxy feature, refer to the "SNMP" chapter of the
Cisco ONS 15310-MA SDH Reference Manual.
Click Apply.
Step 8
Step 9
Return to your originating procedure (NTP).

DLP-H226 Set Up SNMP for an ENE

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP tabs.
Step 1
In the Trap Destinations area, click Create.
Step 2
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-24
The community name is a form of authentication and access control. The community name
Note
assigned to the ONS 15310 is case-sensitive and must match the community name of the
NMS.
UDP Port—The default User Datagram Protocol (UDP) port for SNMP traps is 162.
Trap Version—Choose either SNMPv1 or SNMPv2. Refer to your NMS documentation to determine
whether to use SNMPv1 or SNMPv2.
In ONS 15310 Software R9.0 and later, you can configure IPv6 addresses for SNMPv1/v2 on a
GNE, in addition to IPv4 addresses.
This procedure provisions the SNMP parameters for an ONS 15310-MA
SDH configured to be an ENE if you use SNMP proxy on the GNE.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Chapter 18
DLPs H200 to H299
78-19416-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents