Dlp-H62 Provision A Vc Low-Order Path Tunnel Route - Cisco ONS 15310-MA SDH Procedure Manual

If you need to create a secondary destination, for example, a path protection bridge/selector circuit exit
Step 10
point in a multivendor path protection configuration, click Use Secondary Destination and repeat Steps
7 through
Click Next.
Step 11
Step 12 Return to your originating procedure (NTP).

DLP-H62 Provision a VC Low-order Path Tunnel Route

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
Step 1
already selected. Arrows indicate the available spans for routing the tunnel from the source node.
Click the arrow of the span you want the VC low-order path tunnel to travel. The arrow turns white. In
Step 2
the Selected Span area, the From and To fields display the slot and port that will carry the tunnel. The
source VC high-order path appears.
Step 3 If you want to change the source VC high-order path, change it in the Source VC high-order path field;
otherwise, continue with the next step.
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 4
Repeat Steps
Step 5
intermediary nodes.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-80
9 to define the secondary destination.
This task provisions the route for a manually routed VC low-order path
tunnel.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Route Review and Edit page must be open.
As needed
Onsite or remote
Provisioning or higher
3 and 4 until the tunnel is provisioned from the source to the destination node through all
Chapter 16 DLPs H1 to H99
78-19416-01