Ntp-H74 Create A J1 Path Trace; Ntp-H75 Create A J2 Path Trace - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 6 Manage Circuits

NTP-H74 Create a J1 Path Trace

Purpose
Tools/Equipment
Prerequisite Procedures Path trace can be provisioned on STM-M (VC high/low-order path) and
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
network where you will create the path trace. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the
on page
As needed, complete the
Step 3
Stop. You have completed this procedure.

NTP-H75 Create a J2 Path Trace

Purpose
Tools/Equipment
Prerequisite Procedures See
Required/As Needed
Onsite/Remote
Security Level
You cannot create a J2 path trace on a TL1-like circuit.
Note
This procedure assumes you are setting up path trace on a bidirectional circuit and setting up transmit
Note
strings at the circuit source and destination.
Complete the
Step 1
create the path trace. If you are already logged in, continue with Step 2.
78-19416-01
This procedure creates a repeated, fixed-length string of characters used to
monitor interruptions or changes to circuit traffic.
ONS 15310-MA SDH cards capable of transmitting and/or receiving path
trace must be installed. See
Electrical circuits. See
Tunnels."
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H121 Provision Path Trace on Circuit Source and Destination Ports" task
17-27.
"DLP-H122 Provision Path Trace on STM-M Ports" task on page
This procedure creates a repeated, fixed-length string of characters used to
monitor interruptions or changes to circuit traffic.
ONS 15310-MA SDH cards capable of transmitting and/or receiving path
trace must be installed. See
Chapter 5, "Create Circuits and VC Low-order Path Tunnels."
circuit creation procedures.
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Table 17-6 on page 17-27
Chapter 5, "Create Circuits and VC Low-order Path
for STM-M and Electrical circuit creation procedures.
on an ONS 15310-MA SDH node on the
Table 17-6 on page 17-27
at a node on the network where you will
Before You Begin
for a list of cards.
17-30.
for a list of cards.
for
6-7