Dlp-H120 Delete Overhead Circuits - Cisco ONS 15310-MA SDH Procedure Manual

Obtain the original IP address of the node in question.
Step 1
From the View menu, choose Go to Network View.
Step 2
From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Step 3
Review the text in the IP Repair wizard and click Next.
Step 4
In the Node IP address area, complete the following:
Step 5
•
•
Step 6 Click Next.
Step 7 Click Finish.
Step 8 Return to your originating procedure (NTP).

DLP-H120 Delete Overhead Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting overhead circuits is service affecting if the circuits are in service (unlocked). To put circuits out
Caution
of service (OOS), see the
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > Overhead Circuits tabs.
Step 2
Click the overhead circuit that you want to delete: user data, IP-encapsulated tunnel, or DCC tunnel.
Step 3
Click Delete.
Step 4
In the confirmation dialog box, click Yes to continue.
Step 5
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-26
Node—Choose the node that has an OOS-PARTIAL circuit.
Old IP Address—Type the node's original IP address.
This task deletes overhead circuits. Overhead circuits include DCC
tunnels, IP-encapsulated tunnels, and user data channels.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
"DLP-H50 Change the Service State for a Port" task on page
Chapter 17 DLPs H100 to H199
16-67.
78-19416-01