Cisco ONS 15310-MA SDH Procedure Manual page 482

From the Circuit Roll Type drop-down list, choose Single to indicate that you want to roll a single
b.
connection from the Roll From circuit to the Roll To circuit.
c. In the Roll From Circuit area, click the circuit that contains the Roll From connection.
Click Next.
Step 6
In the Pivot/Fixed Point 1 window, click the square representing the facility that you want to keep
Step 7
(Figure 17-3 on page
This facility is the fixed location in the cross-connect involved in the roll process. The identifier appears
in the text box below the graphic image. The facility that is not selected is the Roll From path. The
Roll From path is deleted after the roll is completed.
Click Next.
Step 8
In the Select New End Point area, choose the Slot, Port, and VC high-order path from the drop-down
Step 9
lists to identify the Roll To facility on the connection being rolled.
Click Finish.
Step 10
The statuses of the Roll From and Roll To circuits change from DISCOVERED to ROLL_PENDING in
the Circuits tab.
Click the Rolls tab. For the pending roll, view the Roll Valid Signal status. When one of the following
Step 11
conditions are met, continue with
If the Roll Valid Signal status is true, a valid signal was found on the new port.
•
If the Roll Valid Signal status is false, a valid signal was not found. Wait until the signal is found
•
before continuing with the next step. To cancel the roll, see the
page
The roll is a one-way destination roll and the Roll Valid Signal is false. It is not possible to get a
•
"true" Roll Valid Signal status for a one-way destination roll.
Note
A roll can be forced onto the Roll To Circuit destination without a valid signal by using the Force
•
Valid Signal button. If you choose Force Valid Signal, traffic on the circuit that is involved in the
roll will be dropped once the roll is completed.
Step 12 If you selected Manual in
to the new port. If you selected Auto, continue with
Step 13 For both manual and automatic rolls, click Finish to complete the circuit roll process.
The roll is cleared from the Rolls tab and the new rolled circuit on Circuits tab returns to the
DISCOVERED status.
Step 14 Return to your originating procedure (NTP).
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-76
17-73).
Step
17-84.
You cannot cancel an automatic roll after a valid signal is found.
Step 5, click the roll on the Rolls tab and click Complete to route the traffic
12.
Step 13.
Chapter 17 DLPs H100 to H199
"DLP-H189 Cancel a Roll" task on
78-19416-01