Dlp-H109 Filter The Display Of Circuits - Cisco ONS 15310-MA SDH Procedure Manual

•
•
Return to your originating procedure (NTP).
Step 3

DLP-H109 Filter the Display of Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
•
Click the Circuits tab.
Step 2
Set the attributes for filtering the circuit display:
Step 3
a.
b.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-12
# of Spans—The number of inter-node links that constitute the circuit. Right-clicking the column
shows a shortcut menu from which you can choose Span Details to show or hide circuit span detail.
State—The circuit service state, which is an aggregate of the service states of its cross-connects:
unlocked—All cross-connects are in the In-Service and Normal (unlocked-enabled) service
–
state.
– OOS—All cross-connects are in the Out-of-Service and Management, Disabled
(locked-enabled,disabled) and/or Out-of-Service and Management, Maintenance
(locked-enabled,maintenance) service state.
OOS-PARTIAL—At least one cross-connect is unlocked-enabled and others are
–
locked-enabled,disabled and/or locked-enabled,maintenance.
This task filters the display of circuits in the ONS network, node, or card
view Circuits window based on circuit name, size, type, direction, and
other attributes.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
To filter network circuits, from the View menu choose Go to Network View.
To filter circuits that originate, terminate, or pass through a specific node, from the View menu.
choose Go to Other Node, then choose the node you want to search and click OK.
To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to open the card in card view.
Click the Filter button.
In the General tab of the Circuit Filter dialog box, set the following filter attributes, as necessary:
• Name—Enter a complete or partial circuit name to filter circuits based on the circuit name;
otherwise leave the field blank.
Direction—Choose one: Any (direction not used to filter circuits), 1-way (display only one-way
•
circuits), or 2-way (display only two-way circuits).
Status—Choose a circuit status to filter the circuits. For more information about circuit statuses,
•
see Table 17-5 on page 17-10.
Chapter 17 DLPs H100 to H199
78-19416-01