Dlp-H75 Display Alarms And Conditions Using Time Zone; Dlp-H76 Synchronize Alarms - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
Return to your originating procedure (NTP).
Step 4

DLP-H75 Display Alarms and Conditions Using Time Zone

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu, choose Preferences.
Step 1
The CTC Preferences Dialog box appears
Check the Display Events Using Each Node's Time Zone check box.
Step 2
Click Apply and OK.
Step 3
Return to your originating procedure (NTP).
Step 4

DLP-H76 Synchronize Alarms

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the card, node, or network view, click the Alarms tab.
Step 1
Click Synchronize.
Step 2
This button causes CTC to retrieve a current alarm summary for the card, node, or network. This step is
optional because CTC updates the Alarms window automatically as messages arrive from the node.
Alarms that have been raised during the session will have a check mark in the Alarms window New
column. When you click Synchronize, the check mark disappears.
Return to your originating procedure (NTP).
Step 3
78-19416-01
This task changes the time stamp for events to the time zone of the
ONS 15310-MA SDH node reporting the alarm. By default, the events time
stamp is set to the time zone for the CTC workstation.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
(Figure 16-20).
This task is used to view ONS 15310-MA SDH events at the card, node, or
network level and to refresh the alarm listing so that you can check for new
and cleared alarms and conditions.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-93