Dlp-H14 Install Ds-3/E3 Cables With Minibnc Connectors On The Ons 15310-Ma Sdh - Cisco ONS 15310-MA SDH Procedure Manual

Table 16-4
Transmit Cable Signal
Pin Connection
47 Unused
48 Unused
Connect the male connector on the cable to the female connector at the center of the front of the
Step 3
ONS 15310-MA SDH
Figure 16-10
Tighten the two thumbscrews on the male connector.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-H14 Install DS-3/E3 Cables With MiniBNC Connectors on the ONS
15310-MA SDH
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-16
E1 Connector Pin Assignments (continued)
Conductor Color Pin
— 95
— 96
(Figure 16-10).
Installing the E1 Cable
This task installs the DS-3/E3 cables to connect DS-3/E3 signals to the
ONS 15310-MA SDH. The DS-3/E3 cables should be terminated with
miniBNC connectors on the ONS 15310-MA SDH side and BNC
connectors on the client side.
Shielded coaxial cable terminated with miniBNC connectors for DS-3/E3
ports
As needed
Receive Cable Signal
Connection Conductor Color
Unused —
Unused —
Chapter 16 DLPs H1 to H99
78-19416-01