Dlp-H194 Change The Optical Line Rate - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199
Onsite/Remote
Security Level
If you plug in a single-rate SFP, the PPM will autoprovision and no further steps are necessary. If you
Note
plug in a multirate SFP, you need to provision the PPM and then provision the rate on the PPM tab by
following this task. This is the node default behavior, but it can be changed by NE default settings. Refer
to the
In node view, for the ONS 15310-MA SDH, double-click the 15310E-CTX-K9 card.
Step 1
Click the Provisioning > Pluggable Port Modules tabs.
Step 2
In the Pluggable Ports area, click Create. The Create Port dialog box appears.
Step 3
In the Create Port dialog box, complete the following:
Step 4
•
•
Click OK.
Step 5
Repeat Steps
Step 6
Step 7 Click OK.
Step 8 Return to your originating procedure (NTP).

DLP-H194 Change the Optical Line Rate

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 15310E-CTX-K9 card.
Step 1
Click the Provisioning > Pluggable Port Modules tabs.
Step 2
Click the port with the port rate that you want to change in the Pluggable Ports area. The highlight
Step 3
changes to dark blue.
Click Edit. The Edit Port Rate dialog box appears.
Step 4
78-19416-01
Onsite or remote
Provisioning or higher
"NTP-H137 Edit Network Element Defaults" procedure on page
Port—Select the PPM number and port number from the drop-down list. The first number indicates
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
with one port displays as 1-1 and the second PPM with one port displays as 2-1. The PPM number
can be 1 to 4, but the port number is always 1.
Port Type—Click the type of port from the drop-down list. The port type list displays the supported
port rates on your PPM. For the 15310E-CTX-K9 in the 15310-MA SDH, STM1, STM4, and
STM16 rates are supported.
3 through 5 to configure the port rates as needed.
This task changes the port rate on a multirate PPM. Multirate PPMs for the
ONS 15310-MA SDH support STM1, STM4, and STM16 line rates.
None
DLP-H29 Log into CTC, page 16-43
DLP-H192 Provision a Multirate Pluggable Port Module, page 17-88
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
14-18.
17-89