Dlp-H42 Set Up Or Change Routing Information Protocol - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H42 Set Up or Change Routing Information Protocol

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Network > RIP tabs.
Step 1
Check the RIP Active check box if you are activating RIP.
Step 2
Step 3 Choose either RIP Version 1 or RIP Version 2 from the drop-down list, depending on which version is
supported in your network.
Set the RIP metric. The RIP metric can be set to a number between 1 and 15 and represents the number
Step 4
of hops.
By default, RIP is set to No Authentication. If the router that the ONS 15310-MA SDH is connected to
Step 5
requires authentication, complete the following steps. If not, continue with
a.
b.
c.
The authentication button label changes to Simple Password.
If you want to complete an address summary, complete the following steps. If not, continue with
Step 6
Complete the address summary only if the ONS 15310-MA SDH is a GNE with multiple ONS 15310
ENEs attached with IP addresses in different subnets.
a.
b.
c.
Return to your originating procedure (NTP).
Step 7
78-19416-01
This task enables Routing Information Protocol (RIP) on the
ONS 15310-MA SDH. Perform this task if you want to include the node in
RIP-enabled networks.
None
DLP-H29 Log into CTC, page 16-43
You need to create a static route to the router adjacent to the
ONS 15310-MA SDH if the ONS 15310 needs to communicate its routing
information to non-DCC-connected nodes.
As needed
Onsite or remote
Provisioning or higher
Click the No Authentication button.
In the Edit Authentication Key dialog box, complete the following:
Type—Choose Simple Password.
•
Enter Authentication Key—Enter the password.
•
Confirm Authentication Key—Enter the same password to confirm it.
•
Click OK.
In the RIP Address Summary area, click Create.
In the Create Address Summary dialog box, complete the following:
• Summary Address—Enter the summary IP address.
• Mask Length—Enter the subnet mask length using the up and down arrows.
• Cost—The RIP Priority level. The smaller the number, the higher the priority.
Click OK.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Step 6.
Step 7.
16-59