Ntp-H45 Create A Vc Low-Order Path Aggregation Point - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
Click Next.
Step 8
In the Circuit Source area, choose the node where the VC low-order path tunnel will originate from the
Step 9
Node drop-down list.
Click Next.
Step 10
In the Circuit Destination area, choose the node where the VC low-order path tunnel will terminate from
Step 11
the Node drop-down list.
Click Next.
Step 12
In the Circuit Routing Preferences area, uncheck Route Automatically.
Step 13
Click Next. In the Route Review and Edit area, node icons appear for you to route the tunnel. The circuit
Step 14
source node is selected. Green arrows pointing from the source node to other network nodes indicate
spans that are available for routing the tunnel.
Complete the
Step 15
tunnel you are creating. The Circuits window appears.
Verify that the tunnel you just created appears in the circuits list. VC low-order path tunnels are
Step 16
identified by VC low-order path in the Type column.
Stop. You have completed this procedure.

NTP-H45 Create a VC Low-order Path Aggregation Point

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The maximum number of VAPs that you can create depends on the node protection topology and number
Note
of VC-12 circuits that terminate on the node. Assuming no other VC-12 circuits terminate at the node,
the maximum number of VAPs that can terminate at one node is ten for the ONS 15310-MA SDH.
78-19416-01
circuit testing or to suppress circuit alarms temporarily. Change the administrative state to
unlocked; Automatic In Service; or locked, outOfGroup when testing is complete. See the
"DLP-H111 Change a Circuit Service State" task on page
Note A VC low-order path tunnel automatically transitions into the unlocked service state after a
VC low-order path circuit is created.
For additional information about circuit service states, refer to the "Circuits and Tunnels" chapter
in the Cisco ONS 15310-MA SDH Reference Manual.
"DLP-H62 Provision a VC Low-order Path Tunnel Route" task on page 16-80
This procedure creates a VC low-order path aggregation point (VAP).
VAPs allow multiple E1 (VC-12) circuits to be aggregated on a single VC
high-order path on an STM-M port. VAPs allow multiple VC-12 circuits to
aggregate on a single VC4 path.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
17-15.
for the
5-29