Ntp-H59 View Alarm-Affected Circuits - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 8 Manage Alarms

NTP-H59 View Alarm-Affected Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
In the network, node, or card view, click the Alarms tab or Conditions tab and then right-click anywhere
Step 2
in the row of an active alarm or condition.
Note
The Select Affected Circuit option appears on the shortcut menu
Figure 8-2
Left-click or right-click Select Affected Circuits.
Step 3
The Circuits window appears with the affected circuits highlighted.
If you want to search for particular circuits, see the
Step 4
78-19416-01
Use this procedure to view all circuits, if any, affected by an alarm or
condition.
None
NTP-H57 View Alarms, History, Events, and Conditions, page 8-2
As needed
Onsite or remote
Retrieve or higher
"DLP-H29 Log into CTC" task on page
The node view is the default, but you can also navigate to the Alarms tab in the network view or
card view to perform Step 2.
ONS 15310-MA SDH Select Affected Circuits Option
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-43. If you are already logged in, continue with
(Figure 8-2).
"DLP-H78 Search for Circuits" task on page
Before You Begin
16-95.
8-5