Dlp-H191 Provision Ce-100T-8 And Ce-Mr-6 Card Pos Ports - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H191 Provision CE-100T-8 and CE-MR-6 Card POS Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You can provision SDH CCAT or VCAT circuits for the CE-100T-8 and CE-MR-6 card before or after
Note
provisioning the card's Ethernet ports or POS ports. See the
Optical Circuit" procedure on page 5-32
Circuit" procedure on page
In the node view, double-click the CE-100T-8 or CE-MR-6 card graphic to open the card.
Step 1
Click the Provisioning > POS Ports tabs.
Step 2
For each CE-100T-8 or CE-MR-6 port, provision the following parameters:
Step 3
•
•
•
•
Note
Note
Click Apply.
Step 4
Refresh the POS statistics:
Step 5
a.
b.
Return to your originating procedure (NTP).
Step 6
78-19416-01
This task provisions CE-100T-8 and CE-MR-6 card POS ports to carry
traffic.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
5-42, as needed.
Port Name—If you want to label the port, enter the port name.
Admin State—Choose unlocked to put the port in the unlocked-enabled service state. Putting a POS
port in unlocked-enabled also puts the mapped Ethernet port in unlocked-enabled.
Framing Type—Choose GPF-F POS framing (the default) or HDLC POS framing. The framing
type needs to match the framing type of the POS device at the end of the SDH circuit.
Encap CRC—With GFP-F framing, the user can configure a 32-bit CRC (the default) or none
(no CRC). HDLC framing provides a set 32-bit CRC. The CRC should be set to match the CRC of
the POS device on the end of the SDH circuit.
For more details on the interoperabilty of ONS Ethernet cards, including information on
encapsulation, framing, and CRC, refer to the "POS on ONS Ethernet Cards" chapter of the
Cisco ONS 15310-CL and Cisco ONS 15310-MA SDH Ethernet Card Software Feature and
Configuration Guide.
The CE-100T-8 and CE-MR-6 cards use LEX encapsulation, which is the primary POS
encapsulation used in ONS Ethernet cards.
In card view, click the Performance > POS Ports > Statistics tabs.
Click Refresh.
or the "NTP-H51 Create an Automatically Routed VCAT
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"NTP-H47 Create an Automatically Routed
17-87