Ntp-H26 Verify Node Turn-Up - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H26 Verify Node Turn-Up

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you are already logged in, continue with Step 2.
Click the Alarms tab and click Synchronize.
Step 2
a.
b.
Verify that the SW Version and Defaults in the node view status area match the software version and the
Step 3
network element (NE) defaults shown in your site plan.
Step 4 Click the Provisioning > General tabs. Verify that all general node information settings match the
settings of your site plan. If not, see the
on page
Click the Provisioning > Timing tabs. Verify that the timing settings match the settings on your site
Step 5
plan. If not, see the
Click the Provisioning > Network tabs. Ensure that the IP settings and other CTC network access
Step 6
information is correct. If not, see the
Click the Provisioning > Protection tabs. Verify that all protection groups have been created according
Step 7
to your site plan. If not, see the
page
Click the Provisioning > Security tabs. Verify that all users have been created and their security levels
Step 8
and policies match the settings indicated by your site plan. If not, see the
Change Security" procedure on page
Step 9 If SNMP is provisioned on the node, click the Provisioning > SNMP tabs. Verify that all SNMP settings
match the settings of your site plan. If not, see the
page
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4-2
This procedure verifies that each ONS 15310-MA SDH is ready for
network turn up before adding nodes to a network.
None
Chapter 3, "Turn Up a Node"
Required
Onsite
Superuser
"DLP-H29 Log into CTC" task on page 16-43
Verify that the alarm filter is not on. See the
page 16-107 as necessary.
Verify that no unexplained alarms appear on the network. If alarms are present, investigate and
resolve them before continuing. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide if
necessary.
10-2.
"NTP-H82 Change Node Timing" procedure on page
10-4.
10-7.
"DLP-H88 Disable Alarm Filtering" task on
"NTP-H78 Change Node Management Information" procedure
"NTP-H79 Change CTC Network Access" procedure on page
"NTP-H143 Modify or Delete Card Protection Settings" procedure on
10-6.
"NTP-H84 Change SNMP Settings" procedure on
Chapter 4
at any node on the network you will test. If
10-5.
"NTP-H83 Modify Users and
Turn Up a Network
10-2.
78-19416-01