Ntp-H68 Create Or Delete Ethernet Rmon Thresholds - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 7 Monitor Performance
Complete the
Step 1
already logged in, continue with
Complete the
Step 2
as needed.
Complete the
Step 3
page 17-2
Step 4 As needed, use the
page 17-3
Step 5 Complete the
as needed.
Stop. You have completed this procedure.

NTP-H68 Create or Delete Ethernet RMON Thresholds

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Perform any of the following tasks as needed:
Step 2
•
•
Stop. You have completed this procedure.
78-19416-01
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H101 View Ether Ports and POS Ports Statistics PM Parameters" task on page 17-1
"DLP-H102 View Ether Ports and POS Ports Utilization PM Parameters" task on
as needed.
"DLP-H103 Refresh Ethernet PM Counts at a Different Time Interval" task on
to change the display of Ethernet utilization PM counts.
"DLP-H104 View Ether Ports and POS Ports History PM Parameters" task on page 17-3
This procedure creates or deletes remote monitoring (RMON) Ethernet
thresholds for the ONS 15310-MA SDH.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page
DLP-H105 Create Ethernet RMON Alarm Thresholds, page 17-4
DLP-H106 Delete Ethernet RMON Alarm Thresholds, page 17-9
Step 2.
16-43. If you are already logged in, continue with
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
at the node you want to monitor. If you are
7-5