Dlp-H150 Modify Snmp Trap Destination - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H150 Modify SNMP Trap Destination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP tabs.
Step 1
Click the trap that you want to modify in the Trap Destinations dialog box.
Step 2
For a description of SNMP traps, refer to the "SNMP" chapter in the Cisco ONS 15310-MA SDH
Reference Manual.
In the Selected Destination area, you can modify the following:
Step 3
•
•
•
Note
Note
Note
If you want to allow the ONS 15310-MA SDH SNMP agent to accept SNMP SET requests on certain
Step 4
MIBs, check the Allow SNMP Sets check box. If the box is not checked, SET requests are rejected.
If you want to set up the SNMP proxy feature to allow network management, message reporting, and
Step 5
performance statistic retrieval across firewalls, check the Allow SNMP Proxy check box.
Click Apply. SNMP settings are now configured.
Step 6
To view SNMP information for each node, click the node IP address in the Trap Destinations area of the
Step 7
Trap Destinations screen.
Return to your originating procedure (NTP).
Step 8
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-52
This task modifies the SNMP trap destinations on an ONS 15310-MA SDH
including community name, default UDP port, and SNMP trap version.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Community
UDP port
Trap version (SNMPv1 or SNMPv2)
The community name is a form of authentication and access control. The community name
assigned to the ONS 15310-MA SDH is case-sensitive and must match the community name of
the NMS.
The default UDP port for SNMP is 162.
Refer to your NMS documentation to determine which trap version to use.
Chapter 17 DLPs H100 to H199
78-19416-01