Ntp- H16 Set Up A Remote Access Connection To The Node; Ntp-H17 Log Into The Gui - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 2 Connect the PC and Log into the GUI
NTP-H16 Set Up a Remote Access Connection to the Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Connect the modem to the ONS 15310-MA SDH RJ-45 (CRAFT) port. On the 15310-MA SDH, the
Step 1
CRAFT port is located on the 15310E-CTX-K9 card faceplate.
While referring to the modem documentation, complete the following tasks to provision the modem for
Step 2
the node:
•
•
•
Step 3 Continue with the
Stop. You have completed this procedure.

NTP-H17 Log into the GUI

Purpose
Tools/Equipment
78-19416-01
This procedure connects an ONS 15310-MA SDH using a LAN modem. To
complete this procedure:
•
•
Modem and modem documentation
NTP-H13 Set Up Computer for CTC, page 2-1
As needed
Onsite
None
For CTC access, set the modem for Ethernet access.
Assign an IP address to the modem that is on the same subnet as the node.
The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the node.
For assistance on provisioning specific modems, contact the Cisco Technical Assistance
Note
Center (Cisco TAC). See the
section on page xlvii
"NTP-H17 Log into the GUI" procedure on page 2-5
This procedure logs into CTC, the graphical user interface software used to
manage the ONS 15310-MA SDH. This procedure includes optional node
login tasks.
None
A LAN modem must be connected to the ONS 15310-MA SDH.
The LAN modem must be provisioned for the ONS 15310-MA SDH.
To run CTC, the modem must be provisioned for Ethernet access.
"Obtaining Documentation and Submitting a Service Request"
for more information.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
2-5