Ntp-H183 Automatically Provision A Gne To Manage An Ene Using Snmpv3 - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Click Provisioning > SNMP > SNMP V3 > General and note the context engine ID. The context engine
Step 4
ID is required in
Step 5 Double-click the GNE.
Complete the
Step 6
the GNE.
Step 7 Complete the following tasks as needed on the ENE:
•
•
•
Complete the
Step 8
page
remote user created in
Stop. You have completed this procedure.
NTP-H183 Automatically Provision a GNE to Manage an ENE
using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
SNMPv3. If you are already logged in, go to
Go to network view.
Step 2
Double-click the GNE.
Step 3
Complete the
Step 4
the GNE.
Complete the
Step 5
page
When you use the automatic procedure, CTC automatically creates an ons_proxy user on the ENE,
Note
provides ENE user details for the proxy configuration, and the context engine ID of the ENE.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-16
Step 8.
"DLP-H282 Create an SNMPv3 User" task on page 18-81
DLP-H282 Create an SNMPv3 User, page 18-81
DLP-H284 Create Group Access, page 18-82
DLP-H283 Create MIB Views, page 18-82
"DLP-H288 Manually Configure the SNMPv3 Proxy Forwarder Table" task on
18-85. Use the context engine ID from
Step 7.
This procedure describes how to automatically configure a GNE to allow
an NMS to manage an ENE using SNMPv3.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required if you want to implement SNMPv3 on your network.
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H282 Create an SNMPv3 User" task on page 18-81
"DLP-H289 Automatically Configure the SNMPv3 Proxy Forwarder Table" task on
18-86. Use the GNE user that you defined in
Step 4, the local user details created in
on the node on which you want to set up
Step 2.
Step 4 when you configure the Proxy Forwarder table.
Chapter 3 Turn Up a Node
to create an SNMPv3 user on
Step 6, and the
to create an SNMPv3 user on
78-19416-01