Ntp-H34 Open-Ended Path Protection Acceptance Test - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 4 Turn Up a Network
•
•
Note
Step 5 Repeat Steps
Step 6 As needed, complete the
As needed, complete the
Step 7
As needed, complete the
Step 8
point-to-point nodes.
Step 9 Following the documentation provided by the third-party vendor, provision the optical loop leading from
the ONS 15310-MA SDH connection at one end to the ONS 15310-MA SDH connection at the other
end. In other words, you will create an open-ended path protection configuration using procedures for
the third-party equipment.
Continue with the
Step 10
Stop. You have completed this procedure.

NTP-H34 Open-Ended Path Protection Acceptance Test

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
traffic traversing the third-party network. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab and click Synchronize.
Step 3
a.
b.
c.
78-19416-01
Node 2 and 5: Slot 4, Port 2-1
Node 3 and 4: Slot 3, Port 1-1
If an ONS 15310-MA SDH is not connected to a corporate LAN, DCC provisioning must be
performed through a direct (craft) connection. Remote provisioning is possible only after all
nodes in the network have DCC terminations provisioned to in-service STM-M ports.
3 through 4 for each node in the path protection configuration.
"DLP-H47 Provision a Proxy Tunnel" task on page
"DLP-H48 Provision a Firewall Tunnel" task on page
"DLP-H49 Create a Provisionable Patchcord" task on page 16-66
"NTP-H34 Open-Ended Path Protection Acceptance Test" procedure on page
This procedure tests an open-ended path protection configuration.
Test set and cables appropriate to the test circuit you will create
NTP-H34 Open-Ended Path Protection Acceptance Test, page 4-15
As needed
Onsite
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Verify that the alarm filter is not on. See the
page 16-107 as necessary.
Verify that no unexplained alarms appear on the network. If alarms are present, investigate and
resolve them before continuing. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide if
necessary.
Complete the "DLP-H223 Export CTC Data" task on page 18-20
your hard drive.
"DLP-H88 Disable Alarm Filtering" task on
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
16-64.
16-65.
at the node that will be the source node for
to export alarm data to a file on
on both
4-15.
4-15