Dlp-H259 Install Ds-3/E3 Cables - Cisco ONS 15310-MA SDH Procedure Manual

Note
Connect the male connector on the cable to the female connector on the electrical interface assembly
Step 2
(EIA) at the back of the ONS 15310-MA SDH.
Tighten the two thumbscrews on the male connector.
Step 3
Return to your originating procedure (NTP).
Step 4
Note When you use a closed E1 LOROM cable, you need to remove the hex screw of the EIA BIC that faces
the 15305 patch panel, and replace with a tape carrier. Use a tape on this side, in addition to the screw
on the other side.

DLP-H259 Install DS-3/E3 Cables

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
Step 1 Place the cable connector over the desired connection point on the backplane.
Step 2 Using the BNC insertion tool, position the cable connector so that the slot in the connector is over the
corresponding notch at the backplane connection point.
Step 3 Gently push the connector down until the notched backplane connector slides into the slot on the cable
connector.
Turn the cable connector clockwise to lock it into place.
Step 4
Step 5 Tie wrap or lace the cables to the EIA according to Telcordia standards (GR-1275-CORE) or local site
practice.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-62
Refer to the "Shelf Assembly Hardware" chapter in the Cisco ONS 15310-MA SDH Reference
Manual for specific information on E1 cables and E1 connectors, including product numbers and
compatibility.
This task installs the DS-3/E3 cables to connect DS-3/E3 signals to the
ONS 15310-MA SDH.
Shielded coaxial cable terminated with BNC connectors for DS-3/E3 ports
BNC insertion/removal tool (see the Cisco ONS 15310-MA SDH Reference
Manual for information about obtaining the BNC insertion/removal tool)
As needed
Onsite
None
Guide.
Chapter 18 DLPs H200 to H299
Cisco ONS Electrostatic Discharge
78-19416-01