Cisco ONS 15310-MA SDH Procedure Manual page 429

Chapter 17 DLPs H100 to H199
Click the source node icon if it is not already selected.
b.
Starting with a span on the source node, click the arrow of the span you want the member to travel.
c.
The arrow turns white. In the Selected Span area, the From and To fields provide span information.
If you want to change the source, adjust the Source VC high-order path field; otherwise, continue
d.
with Step e.
e. Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
f. Repeat Steps
through all intermediary nodes. If you selected Fully Protect Path, you must:
•
•
•
Repeat Steps
g.
Step 12 If you checked Route Automatically in
following substeps. If not, continue with
Click Next.
a.
Review the circuit route. To add or delete a circuit span, choose a node on the circuit route. Blue
b.
arrows show the circuit route. Green arrows indicate spans that you can add. Click a span arrowhead,
then click Include to include the span or Remove to remove the span.
If the provisioned circuit does not reflect the routing and configuration you want, click Back to
c.
verify and change circuit information.
Click Finish.
Step 13
Note
If you added an LCAS member, complete the following substeps:
Step 14
Click the Alarms tab and see if the VCAT Group Degraded (VCG-DEG) alarm appears. If it does
a.
appear, refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide for the procedure to clear the
alarm. If it does not, continue with b.
Complete the
b.
member in the unlocked service state.
Step 15 Return to your originating procedure (NTP).
78-19416-01
c through e until the member is provisioned from the source to the destination node
Add two spans for all path protection or unprotected portions of the member route from the
source to the destination.
Add one span for all 1+1 portions of the route from the source to the destination.
For members routed on path protection dual ring interconnect topologies, provision the working
and protect paths.
a through f for each member.
Adding members to a VCAT circuit may take several minutes depending on the complexity of
the network and the number of members to be added.
"DLP-H180 Change a VCAT Member Service State" task on page 17-70
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Step 8 and checked Review Route Before Creation, complete the
Step 13.
to put the
17-23