Ntp- H150 Install The Shelf Assembly - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH
Complete the
Step 1
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
NTP-H150 Install the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The ONS 15310-MA SDH is suitable for installation in network telecommunication facilities where
Note
National Electric Code (NEC) applies.
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of 149°F (65°C). Statement 1047
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack. Statement 1006
78-19416-01
"DLP-H1 Unpack and Verify the Shelf Assembly" task on page
"DLP-H2 Inspect the Shelf Assembly" task on page
"NTP-H150 Install the Shelf Assembly" procedure on page
This procedure describes how to mount ONS 15310-MA SDH shelf
assemblies in a rack.
#2 Phillips screwdriver
#12-24 mounting screws (4)
#10-32 ear mounting screws (8)
Universal mounting ears (2)
Dual-assembly plate
19-inch-rack mounting ear
Fuse and alarm panel, if not installed
NTP-H149 Unpack and Inspect the ONS 15310-MA SDH Shelf Assembly,
page 1-4
Required
Onsite
None
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
16-1.
16-1.
1-5.
1-5