Dlp-H220 Soft-Reset An Ethernet Or Electrical Card Using Ctc - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Right-click the card to reveal a shortcut menu.
Step 5
Click Hard-reset Card.
Step 6
Click Yes in the "Are you sure you want to hard-reset this card?" dialog box.
Step 7
Return to your originating procedure (NTP).
Step 8

DLP-H220 Soft-Reset an Ethernet or Electrical Card Using CTC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not soft reset more than one ONS 15310-MA SDH card at a time. Instead, issue a soft reset command
Caution
for a single card, then wait until CTC shows the card is back up. You can then issue a soft reset on another
card if needed. Completing soft resets in sequence helps to avoid unexpected traffic hits.
Soft-resetting an Ethernet card causes a traffic hit. However, soft-resetting a traffic card is errorless in
Caution
most cases. If there is a provisioning change during the soft reset, or if the firmware is replaced during
the software upgrade process, the reset is not errorless.
In node view, right-click the card to reveal a shortcut menu.
Step 1
Click Soft-reset Card.
Step 2
Click Yes in the "Are you sure you want to soft-reset this card?" dialog box.
Step 3
Return to your originating procedure (NTP).
Step 4
78-19416-01
This task resets the ML-100T-8, CE-100T-8, E1_21_E3_DS3_3, or
E1_63_E3_DS3_3 card using a soft reset. A soft reset reboots the card
and reloads the operating system and the application software.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Maintenance or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-17