Cisco ONS 15310-MA SDH Procedure Manual page 535

Chapter 18 DLPs H200 to H299
Table 18-3
Parameter
SF BER
SD BER
Line Type
Line Coding
Line Length
automaticInServi
ce Soak
Provides Sync
SyncMsgIn
Send DoNotUse
Enable Retiming
78-19416-01
Line Options for E1 Ports (continued)
Description
Sets the signal fail bit error
rate.
Sets the signal degrade bit
error rate.
Defines the line framing
type.
Defines the E1 transmission
coding type.
Defines the distance (in feet)
from backplane connection
to the next termination
point.
Automatic in-service soak.
(Display only) If checked,
the card is provisioned as a
NE timing reference.
Enables synchronization
status messages (S1 byte),
which allow the node to
choose the best timing
source.
When checked, sends a do
not use (DUS) message on
the S1 byte.
Retiming is an option that,
when enabled, removes
accumulated jitter and
wander from synchronous
transport network payload
signals.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Options
1E-3
•
1E-4 (default)
•
1E-5
•
1E-5
•
1E-6
•
• 1E-7 (default)
• 1E-8
• 1E-9
D4
•
ESF—Extended Super Frame
•
Unframed
•
AUTO PROVISION FMT
•
AMI—Alternate Mark Inversion (default)
•
B8ZS—Bipolar 8 Zero Substitution
•
0 - 131 (default)
•
• 132 - 262
• 263 - 393
• 394 - 524
525 - 655
•
Duration of valid input signal in hh.mm after
•
which the port is set in service by the software.
0 to 48 hours, 15-minute increments
•
Yes (checked)
•
No (unchecked)
•
Yes (checked, default)
•
No (unchecked)
•
Yes (checked)
•
• No (unchecked, default)
Yes (checked)
•
• No (unchecked, default)
18-35