Dlp-H211 Edit The Osi Router Configuration; Dlp-H212 Edit The Osi Subnetwork Point Of Attachment - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H211 Edit the OSI Router Configuration

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
Step 1 In node view, click the Provisioning > OSI > Routers > Setup tabs.
Step 2 Choose the router you want provision and click Edit.
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
Step 4 Return to your originating procedure (NTP).

DLP-H212 Edit the OSI Subnetwork Point of Attachment

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In the node view, click the Provisioning > OSI > Routers > Subnet tabs.
Step 1
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-10
This task edits the OSI router configuration, including enabling and
disabling OSI routers, editing the primary area address, and creating or
editing additional area addresses.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Check or uncheck the Enabled box to enable or disable the router.
Router 1 must be enabled before you can enable Routers 2 and 3.
Note
For enabled routers, edit the primary area address, if needed. The address can be between
8 and 24 alphanumeric characters in length.
If you want to add or edit an area address to the primary area, enter the address at the bottom of the
Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length.
Click Add.
Click OK.
This task allows you to view and edit the OSI subnetwork point of
attachment parameters. The parameters are initially provisioned when you
create a Section DCC (RS-DCC), Line DCC (MS-DCC), generic
communications channel (GCC), or optical service channel (OSC), or when
you enable the LAN subnet.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01