Dlp-H88 Disable Alarm Filtering; Dlp-H89 Refresh Pm Counts For A Different Port - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
Return to your originating procedure (NTP).
Step 5

DLP-H88 Disable Alarm Filtering

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At the node, network, or card view, click the Alarms tab.
Step 1
Click the Filter tool at the lower-right side of the bottom toolbar.
Step 2
Alarm filtering is enabled if the tool is indented and disabled if the tool is raised (not selected).
If you want alarm filtering disabled when you view conditions, click the Conditions tab and click the
Step 3
Filter tool.
If you want alarm filtering disabled when you view alarm history, click the History tab and click the
Step 4
Filter tool.
Return to your originating procedure (NTP).
Step 5

DLP-H89 Refresh PM Counts for a Different Port

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 15310E-CTX-K9 card, or the Ethernet card. The card view appears.
Step 1
Step 2 Click the Performance tab.
•
•
Step 3 From the Port drop-down list, choose the target port to highlight your selection.
78-19416-01
This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
None
DLP-H84 Enable Alarm Filtering, page 16-102
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
To refresh PM Counts for optical ports, click the Optical tab.
To refresh PM Counts for ML-Series and CE-Series Ethernet cards, click the Ether Ports > History
tabs or POS Ports > History tabs.
This task changes the window view to display PM counts for another
port on a multiport card.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-107