Ntp-H40 Create An Automatically Routed Ds-3 Or E3 Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
Verify that the new drops appear in the Destination column for the circuit you edited. If they do not
Step 25
appear repeat Steps
Step 26 Complete the
test circuit.
Stop. You have completed this procedure.

NTP-H40 Create an Automatically Routed DS-3 or E3 Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
Step 3 From the View menu, choose Go to Network View.
Step 4 Click the Circuits tab, then click Create.
In the Circuit Creation dialog box, complete the following fields:
Step 5
•
•
•
Click Next.
Step 6
Define the circuit attributes:
Step 7
•
•
•
78-19416-01
5 through 24, making sure all options are provisioned correctly.
"NTP-H46 Test Electrical Circuits" procedure on page
This procedure creates an automatically routed DS-3 or E3 circuit. CTC
routes the circuit automatically based on circuit creation parameters and
the software version.
None
NTP-H36 Verify Network Turn-Up, page 5-4
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H56 Assign a Name to a Port" task on page
Circuit Type—Choose VC high-order path (both DS-3 and E3) or VC low-order path (E3 only).
Number of Circuits—Enter the number of DS-3 or E3 circuits that you want to create. The default
is 1. If you are creating multiple circuits with sequential source and destination ports, you can use
autoranging to create the circuits automatically.
Auto-ranged—This check box is automatically selected if you enter more than 1 in the Number of
Circuits field. Leave selected if you are creating multiple DS-3 or E3 circuits with the same source
and destination and you want CTC to create the circuits automatically. Uncheck this check box if
you do not want CTC to create sequential circuits automatically.
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Size—If you are creating a VC high-order path circuit, choose VC3. If you are creating a VC
low-order path circuit, Size displays VC-12 and cannot be changed.
Bidirectional—Leave the default (checked) for this circuit.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
5-24. Skip this step if you built a
at a node on the network where you will
Step 2.
16-75. If not, continue with Step 3.
5-15