Ntp-H276 Create Ftp Host - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 3 Turn Up a Node

NTP-H276 Create FTP Host

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you want to set up timing. If you are already logged in, continue with
In Node view, click the Provisioning > Network > FTP Hosts tabs.
Step 2
Click Create.
Step 3
Enter a valid IP address in the FTP Host Address field. A maximum of 12 host can be entered.
Step 4
In ONS 15310 Software Release 9.0 and later, you can configure an IPv6 address for an FTP server, in
Note
addition to an IPv4 address.
The Mask is automatically set according to the Net/Subnet Mask length specified in DLP-C39. To
Step 5
change the Mask, click the Up/Down arrows on the Length menu.
Check the FTP Relay Enable radio button to allow FTP commands at the GNE relay. If you will enable
Step 6
the relay at a later time, go to
into the Data Communication Network (DCN), the FTP relay on the GNE provides this access. The FTP
hosts that you have configured in CTC can be used with the TL1 COPY-RFILE (for database backup and
restore or software download) or COPY-IOSCFG (for Cisco IOS Configuration File backup and restore)
commands.
Enter the time, in minutes, that FTP Relay will be enabled. A valid entry is a number between 0 and 60.
Step 7
The number 0 disallows FTP command relay. After the specified time has elapsed the FTP Relay Enable
flag is unset and FTP command relay is disallowed.
Click OK.
Step 8
Repeat
Step 9
Stop. You have completed this procedure.
78-19416-01
This procedure provisions an FTP Host that you can use to perform
database backup and restore or software download to an End Network
Element (ENE) when proxy or firewall is enabled.
None
NTP-H21 Set Up CTC Network Access, page 3-6
NTP-H22 Set Up the ONS 15310-MA SDH for Firewall Access, page 3-7
As needed
Onsite or remote
Superuser
"DLP-H29 Log into CTC" task on page 16-43
Step
Step 3 through Step 8 to provision additional FTP hosts.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at the ONS 15310-MA SDH node where
8. Certain TL1 commands executed on an ENE require FTP access
Before You Begin
Step 2.
3-9