Ntp-H21 Set Up Ctc Network Access - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Review the node information. If you need to make corrections, repeat Steps
Step 6
corrections. If the information is correct, continue with the
procedure on page
Stop. You have completed this procedure.

NTP-H21 Set Up CTC Network Access

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the
Step 2
SDH IP address, subnet mask, default router, DHCP server, IIOP listener port, and proxy server settings.
If static routes are needed, complete the
Step 3
the "Management Network Connectivity" chapter in the Cisco ONS 15310-MA SDH Reference Manual
for further information about static routes.
If the ONS 15310-MA SDH is connected to a LAN or WAN that uses OSPF and you want to share
Step 4
routing information between the LAN/WAN and the ONS network, complete the
Change Open Shortest Path First Protocol" task on page
Step 5 If the ONS 15310-MA SDH is connected to a LAN or WAN that uses RIP, complete the
Up or Change Routing Information Protocol" task on page
Step 6 Complete the
network is provisioned and one or more of the following conditions exist:
•
•
•
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-6
3-6.
This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, proxy server
settings, static routes, Open Shortest Path First (OSPF) protocol, Routing
Information Protocol (RIP), and designated SOCKS servers.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required
Onsite or remote
Superuser
"DLP-H29 Log into CTC" task on page
"DLP-H39 Provision IP Settings" task on page 16-52
"DLP-H274 Provision the Designated SOCKS Servers" task on page 18-73
SOCKS proxy is enabled.
The ratio of ENEs to GNEs is greater than eight to one.
Most ENEs do not have LAN connectivity.
"NTP-H21 Set Up CTC Network Access"
16-43. If you are already logged in, continue with
"DLP-H40 Create a Static Route" task on page
16-56.
16-59.
Chapter 3 Turn Up a Node
3 to 5 to enter the
to provision the ONS 15310-MA
16-55. Refer to
"DLP-H41 Set Up or
"DLP-H42 Set
after the
78-19416-01