Dlp-H117 Delete A Member From A Vcat Circuit - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H117 Delete a Member from a VCAT Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting a member from a non-LCAS circuit can be service-affecting.
Caution
Deleting LCAS members in the unlocked-enabled or unlocked-disabled,automaticInService service
Caution
state can be service affecting. Cisco recommends putting the LCAS member to be deleted in the
locked-enabled,outOfGroup service state before deleting. Non-LCAS members do not support the
locked-enabled,outOfGroup service state.
In node or network view, click the Circuits tab.
Step 1
Click the VCAT circuit that you want to edit, then click Edit.
Step 2
Step 3 Click the Members tab.
Step 4 Select the member that you want to delete. To select multiple members, press Ctrl and click the desired
members.
Click Delete Member.
Step 5
You cannot delete members from VCAT circuits that use ONS 15454 ML-Series cards as a circuit source
or destination.
In the confirmation dialog box, click Yes.
Step 6
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-24
This task removes a member from a non-LCAS or LCAS VCAT circuit on
CE-100T-8, CE-MR-6, or ML-100T-8 cards. This task reduces the size of
the VCAT circuit. You cannot delete members from VCAT circuits that use
ONS 15454 ML-Series cards as a circuit source or destination.
CE-100T-8, CE-MR-6, or ML-100T-8 card
DLP-H29 Log into CTC, page 16-43
VCAT circuits must exist on the network. See
and VC Low-order Path Tunnels"
As necessary, complete the
State" task on page 17-70
locked-enabled,outOfGroup.
As needed
Onsite or remote
Provisioning or higher
Chapter 17
Chapter 5, "Create Circuits
for circuit creation procedures.
"DLP-H180 Change a VCAT Member Service
to change a LCAS member state to
DLPs H100 to H199
78-19416-01