Ntp- H169 Install The Cable Management Bracket - Cisco ONS 15310-MA SDH Procedure Manual

Required Tools and Equipment
Complete the necessary rack mount task
Step 1
page 18-50.
Continue with the
Step 2
Stop. You have completed this procedure.
NTP-H169 Install the Cable Management Bracket
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
Step 1 Line up the three screw holes on the rear of the bracket with the screw holes at the bottom of the
ONS 15310-MA SDH shelf assembly
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-6
DLP-H248 Mount a Single ONS 15310-MA SDH in a Rack,
"NTP-H169 Install the Cable Management Bracket" procedure on page
This procedure describes how to install the cable management bracket,
which is used for routing optical and Ethernet cables.
#2 Phillips screwdriver
Standard cable management bracket and
three #8-32 x 0.31 inch (0.79 cm) screws (included with the ship kit)
or
Extended cable management bracket (15310-CBLMGT) and
five 8-32 x 0.31 inch (0.79 cm) screws
NTP-H150 Install the Shelf Assembly, page 1-5
Required
Onsite
None
(Figure
Chapter 1
1-1).
Install the Cisco ONS 15310-MA SDH
1-6.
78-19416-01