Ntp-H48 Create A Manually Routed Optical Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 5 Create Circuits and VC Low-order Path Tunnels
•
•
In the Circuits window, verify that the circuits you created appear in the circuits list.
Step 19
Complete the
Step 20
circuit.
Stop. You have completed this procedure.

NTP-H48 Create a Manually Routed Optical Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
create the circuit. If you are already logged in, continue with
If you want to assign a name to the tunnel source and destination ports before you create the circuit,
Step 2
complete the
Complete the following as necessary (you can provision Ethernet or POS ports before or after the VC
Step 3
high-order path circuit is created):
•
•
From the View menu, choose Go to Network View.
Step 4
In the Circuit Creation dialog box, complete the following fields:
Step 5
•
•
•
Click Next.
Step 6
78-19416-01
If you entered more than 1 in Number of Circuits and chose Auto-ranged, CTC automatically creates
the number of circuits entered in Number of Circuits. If autoranging cannot complete all the circuits,
for example, because sequential ports are unavailable on the source or destination, a dialog box
appears. Set the new source or destination for the remaining circuits, then click Finish to continue
autoranging. After completing the circuits, the Circuits window appears.
If you entered more than 1 in Number of Circuits and did not choose Auto-ranged, the Circuit
Creation dialog box appears for you to create the remaining circuits. Repeat Steps
each additional circuit. After completing the circuits, the Circuits window appears.
"NTP-H50 Test Optical Circuits" procedure on page
This procedure creates a manually routed optical circuit.
None
NTP-H36 Verify Network Turn-Up, page 5-4
NTP-H130 Manage Pluggable Port Modules, page 9-3
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H56 Assign a Name to a Port" task on page
To provision Ethernet ports for CE-100T-8 or CE-MR-6 circuits, complete the
Provision CE-100T-8 and CE-MR-6 Card Ethernet Ports" task on page
To provision POS ports for CE-100T-8 or CE-MR-6 circuits, complete the
CE-100T-8 and CE-MR-6 Card POS Ports" task on page
Circuit Type—Choose VC high-order path or VC low-order path.
Number of Circuits—Enter the number of optical circuits that you want to create. The default is 1.
Auto-ranged—Applies to automatically routed circuits only. If you entered more than 1 in the
Number of Circuits field, uncheck this box. (The box is unavailable if only one circuit is entered in
Number of Circuits.)
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
7
5-41. Skip this step if you built a test
(as needed)
at a node on the network where you will
Step 2.
16-75. If not, continue with
"DLP-H190
17-85.
"DLP-H191 Provision
17-87.
through 17 for
Step 3.
5-35