Before You Begin - Cisco ONS 15310-MA SDH Procedure Manual

Turn Up a Network
This chapter explains how to turn up and test Cisco ONS 15310-MA SDH nodes in a network, including
terminal point-to-point networks and path protection configurations.

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
78-19416-01
NTP-H26 Verify Node Turn-Up, page
up.
NTP-H27 Provision a Point-to-Point Network, page
NTP-H28 Point-to-Point Network Acceptance Test, page
create a point-to-point network.
NTP-H29 Provision a Linear ADM Network, page
NTP-H30 Linear ADM Network Acceptance Test, page
create a linear ADM.
NTP-H31 Provision Path Protection Nodes, page
NTP-H32 Path Protection Acceptance Test, page
path protection configuration.
NTP-H33 Provision an Open-Ended Path Protection Configuration, page
complete this procedure after you provision a path protection configuration.
NTP-H34 Open-Ended Path Protection Acceptance Test, page
procedure after you provision an open-ended path protection configuration.
NTP-H146 Provision a Traditional Path Protection Dual-Ring Interconnect on the ONS 15310-MA
SDH, page 4-18—As needed, complete this procedure after you provision a path protection
configuration.
NTP-H147 Provision an Integrated Path Protection Dual-Ring Interconnect on the ONS 15310-MA
SDH, page 4-20—As needed, complete this procedure after you provision a path protection
configuration.
NTP-H35 Create a Logical Network Map, page
C H A P T E R
4-2—Complete this procedure before beginning network turn
4-3—Complete as needed.
4-6—Complete as needed.
4-9—Complete as needed.
4-11—Complete this procedure after you create a
4-22—Complete as needed.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4
4-4—Complete this procedure after you
4-7—Complete this procedure after you
4-13—As needed,
4-15—As needed, complete this
4-1