Dlp-H110 View Circuits On A Span - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H110 View Circuits on a Span

Purpose
Tools/Equipment
Prerequisite Procedures Circuits must be created on the span; see
Required/As Needed
Onsite/Remote
Security Level
From the View menu in node view, choose Go to Network View. If you are already in network view,
Step 1
continue with
Right-click the green line containing the circuits you want to view and choose Circuits to view path
Step 2
protection, 1+1, or unprotected circuits on the span.
In the Circuits on Span dialog box, you can view the following information for circuits provisioned on
the span:
•
•
•
•
•
Note
Step 3 Return to your originating procedure (NTP).
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-14
This task displays circuits routed on an ONS 15310-MA SDH span.
None
VC Low-order Path Tunnels"
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Step 2.
VC high-order path—Displays VC high-order paths used by the circuits.
VC low-order path—Displays VC low-order paths used by the circuits (VC low-order path circuits).
Path Protection—(Path protection span only) If checked, path protection circuits are on the span.
Circuit—Displays the circuit name.
Switch State—(Path protection span only) Displays the switch state of the circuit, that is, whether
any span switches are active. For path protection spans, switch types include: CLEAR (no spans are
switched), MANUAL (a Manual switch is active), FORCE (a Force switch is active), and
LOCKOUT OF PROTECTION (a span lockout is active).
You can perform other procedures from the Circuits on Span dialog box. If the span is in a path
protection configuration, you can switch the span traffic. See the
Protection Force Switch on a Span" task on page 17-58
circuit on the span, double-click the circuit. See the
page 17-16 or the "DLP-H114 Edit Path Protection Circuit Path Selectors" task on page 17-18
for instructions.
Chapter 17
Chapter 5, "Create Circuits and
"DLP-H166 Initiate a Path
for instructions. If you want to edit a
"DLP-H112 Edit a Circuit Name" task on
DLPs H100 to H199
78-19416-01