Dlp-H207 Enable The Osi Subnet On The Lan Interface - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Chose the router where you want provision an additional manual area address and click Edit. The OSI
Step 2
Router Editor dialog box appears.
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 4

DLP-H207 Enable the OSI Subnet on the LAN Interface

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
OSI subnetwork points of attachment are enabled on DCCs when you create DCCs. See the
Note
Provision Section DCC Terminations" task on page 16-68
Terminations" task on page
The OSI subnetwork point of attachment cannot be enabled for the LAN interface if the OSI routing
Note
mode is set to ES (end system).
If Secure Mode is on, the OSI Subnet is enabled on the backplane LAN port, not the front TCC2P port.
Note
In node view, click the Provisioning > OSI > Routers > Subnet tabs.
Step 1
Click Enable LAN Subnet.
Step 2
In the Enable LAN Subnet dialog box, complete the following fields:
Step 3
•
78-19416-01
Check Enable Router to enable the router and make its primary area address available for editing.
Click the manual area address, then click Add.
In the Add Manual Area Address dialog box, enter the primary area address in the Area Address
field. If you prefer, click Use Mask and enter the address in the Masked NSAP Entry dialog box.
The address (hexadecimal format) can be 2 to 24 alphanumeric characters (0–9, a–f) in length.
Click OK successively to close the following dialog boxes: Masked NSAP Entry (if used), Add
Manual Area Address, and OSI Router Editor.
This task enables the OSI subnetwork point of attachment on the LAN
interface.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
16-71.
ESH—Sets the End System Hello (ESH) propagation frequency. End system NEs transmit ESHs to
inform other ESs and ISs about the NSAPs it serves. The default is 10 seconds. The range is 10 to
1000 seconds.
and the
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"DLP-H52
"DLP-H53 Provision Line DCC
18-7