Dlp-H66 Provision A Vcat Circuit Route - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
From the Slot drop-down list, choose the slot containing the ML-100T-8, CE-MR-6, or CE-100T-8 card
Step 2
where the circuit will originate. (If a card's capacity is fully utilized, it does not appear in the list.)
Step 3 Depending on the circuit origination card, choose the source port and/or VC high-order path and, if
applicable, VC low-order path from the Port, VC high-order path, and VC low-order path drop-down
lists. The Port drop-down list is only available if the card has multiple ports.VC high-order paths do not
appear if they are already in use by other circuits. VC low-order paths do not appear for
VC_HO_Path_Circuit circuits or if they are already in use by other circuits.
Click Next.
Step 4
From the Node drop-down list, choose the destination node.
Step 5
From the Slot drop-down list, choose the slot containing the ML-100T-8, CE-MR-6, or CE-100T-8 card
Step 6
where the circuit will terminate (destination card). (If a card's capacity is fully utilized, the card does
not appear in the list.)
Depending on the card selected in
Step 7
applicable, VC low-order path from the Port, VC high-order path, and VC low-order path drop-down
lists. The Port drop-down list is only available if the card has multiple ports.VC high-order paths do not
appear if they are already in use by other circuits. VC low-order paths do not appear for
VC_HO_Path_Circuit circuits or if they are already in use by other circuits.
Click Next.
Step 8
Return to your originating procedure (NTP).
Step 9

DLP-H66 Provision a VCAT Circuit Route

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the Circuit Creation wizard in the Route Review and Edit area, choose the member number from the
Step 1
Route Member Number drop-down list.
Step 2 Click the source node icon if it is not already selected.
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
Step 3
arrow turns white. In the Selected Span area, the From and To fields provide span information. The
source VC high-order path appears.
Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 4
Step 5 Repeat Steps
intermediary nodes.
Repeat this task for each member.
Step 6
78-19416-01
Step
This task provisions the circuit route for manually routed STM-M circuits.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Route Review/Edit page must be open.
As needed
Onsite or remote
Provisioning or higher
3 and 4 until the circuit is provisioned from the source to the destination node through all
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
6, choose the source port and/or VC high-order path and, if
16-83