Dlp-H255 Install The Serial Cable For Tl1 Craft Interface On The Ons 15310-Ma Sdh - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Note
Return to your originating procedure (NTP).
Step 4
DLP-H255 Install the Serial Cable for TL1 Craft Interface on the ONS 15310-MA
SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Plug one end of the TL1 cable into the CRAFT port on the 15310E-CTX-K9 faceplate.
Step 1
Connect the other end to the PC that you want to use to access the craft.
Step 2
Table 18-16
Table 18-16
RJ-45 Pin Number
1
2
3
4
5
6
7
8
Return to your originating procedure (NTP).
Step 3
78-19416-01
For more detailed information about timing, refer to the "Timing" chapter of the
Cisco ONS 15310-MA SDH Reference Manual. To set up system timing, see the
Up Timing" procedure on page
This task installs the serial cable for the TL1 craft interface on the
ONS 15310-MA SDH.
Craft port serial cable, CAT-5 terminated with RJ-45
NTP-H150 Install the Shelf Assembly, page 1-5
As needed
Onsite
None
shows the serial cable pin assignments.
TL1 Serial Cable Pin Assignments
Function
RTS
DTR
TXD
GND
GND
RXD
DSR
CTS
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-10.
"NTP-H23 Set
18-57