Ntp-H86 Modify Line Settings And Pm Parameter Thresholds For Electrical Ports; Ntp-H87 Modify Line Settings And Pm Parameter Thresholds For Optical Ports - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
NTP-H86 Modify Line Settings and PM Parameter Thresholds for
Electrical Ports
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
port settings.
According to site practice, complete the
Step 2
preserve the existing database.
Perform any of the following tasks as needed:
Step 3
•
•
When you have finished changing the port settings, complete the
Step 4
procedure on page 14-2
Stop. You have completed this procedure.
NTP-H87 Modify Line Settings and PM Parameter Thresholds for
Optical Ports
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
port settings. If you are already logged in, continue with Step 2.
According to site practice, complete the
Step 2
preserve the existing database.
Step 3 Perform any of the following tasks as needed:
•
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
9-2
This procedure changes the line and threshold settings for electrical ports.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H233 Change Line and Threshold Settings for E1 Ports" task on page 18-32
"DLP-H236 Change Line and Threshold Settings for DS-3 Ports" task on page 18-39
according to site practice.
This procedure changes the line and threshold settings for the optical ports.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H238 Change Optical Port Line Settings" task on page 18-43
"DLP-H239 Change Optical Port SDH Thresholds Settings" task on page 18-46
at the node where you want to change the
"NTP-H102 Back Up the Database" procedure on page 14-2
"NTP-H102 Back Up the Database"
at the node where you want to change the
"NTP-H102 Back Up the Database" procedure on page 14-2
Chapter 9 Change Port Settings
to
to
78-19416-01