Ntp-H60 Create, Download, And Assign Alarm Severity Profiles - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Stop. You have completed this procedure.

NTP-H60 Create, Download, and Assign Alarm Severity Profiles

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
alarm profile. If you are already logged in, continue with
profile, or go to
Complete the
Step 2
a current alarm profile and then renames and customizes it.
Step 3 Complete the
an alarm severity profile from a CD or a node.
Note
As necessary, complete the
Step 4
"DLP-H82 Apply Alarm Profiles to Cards and Nodes" task on page
As needed, complete the
Step 5
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
8-6
This procedure creates a customized alarm profile at the network, node, or
card level; assigns custom severities individually to a port, card, or node;
and deletes alarm profiles.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Step 3 to download an alarm profile.
"DLP-H79 Create a Cloned Alarm Severity Profile" task on page
"DLP-H80 Download an Alarm Severity Profile" task on page
After storing a created or downloaded alarm profile, you must go to the node (either by logging
into it or clicking on it from the network view) and activate the profile by applying it to the shelf,
one or more cards, or one or more ports.
"DLP-H81 Apply Alarm Profiles to Ports" task on page 16-99
"DLP-H83 Delete Alarm Severity Profiles" task on page
Chapter 8
at the node where you want to create an
Step 2 to create, clone or modify an alarm
16-96. This task clones
16-98. This task downloads
16-100.
16-101.
Manage Alarms
or the
78-19416-01