Ntp-H92 Change Card Or Ppm Service State; Ntp-H172 Provision The Soak Timer For An Ml-100T-8 Card - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H92 Change Card or PPM Service State

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note On the ONS 15310-MA SDH, the pluggable-port module (PPM) is equivalent to an optical port.
Step 1 Complete the
or PPM service state.
Step 2 Click the Inventory tab.
Step 3 Click Admin State for the card or PPM that you want to change, and choose an administrative state from
the drop-down list: unlocked or locked, maintenance.
Step 4 Click Apply.
Step 5 If an error message appears indicating that the card or PPM service state cannot be changed from its
current service state, click OK.
Depending on the administrative state that you choose, the card or port/PPM transitions to a different
service state. For more information about the service states and card state transitions, refer to the
"Administrative and Service States" appendix of the Cisco ONS 15310-MA SDH Reference Manual.
Stop. You have completed this procedure.

NTP-H172 Provision the Soak Timer for an ML-100T-8 Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
soak timer for an ML-100T-8 card. If you are already logged in, continue with Step 2.
In node view, double-click the ML-100T-8 card that you want to provision.
Step 2
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
9-4
This procedure changes the card or port service state, which is an
autonomously generated state that gives the overall condition of the port.
None
Chapter 1, ""
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
This procedure provisions the soak timer for ports on an ML-100T-8 card.
The soak period is the amount of time that the ML-100T-8 port remains in
the Down state after an error-free signal is continuously received before
transitioning to the Up state.
None
NTP-H154 Install the Ethernet Cards, page 1-19
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Chapter 9 Change Port Settings
at the node where you want to change card
at the node where you want to provision the
78-19416-01