Ntp-H25 Set Up Snmp - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
Stop. You have completed this procedure.

NTP-H25 Set Up SNMP

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with Step 2.
In node view, click the Provisioning > SNMP tabs.
Step 2
In the Trap Destinations area, click Create.
Step 3
Complete the following in the Create SNMP Trap Destination dialog box:
Step 4
•
In ONS 15310 Software R9.0 and later, you can configure IPv6 addresses for SNMPv1/v2/v3 trap
Note
destinations, Get/Set requests and proxy targets, in addition to IPv4 addresses.
•
•
•
Click OK. The node IP address of the node where you provisioned the new trap destination appears in
Step 5
the Trap Destinations area.
Click the node IP address in the Trap Destinations area. Verify the SNMP information that appears in
Step 6
the Selected Destination list.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-12
This procedure provisions the SNMP parameters so that you can use
SNMP management software with the ONS 15310-MA SDH.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
Destination IP Address—Type the IP address of your network management system. If the node you
are logged into is an end ONS 15310-MA SDH network element (ENE), set the destination address
to the GNE.
Community—Type the SNMP community name. For a description of SNMP community names,
refer to the "SNMP" chapter in the Cisco ONS 15310-MA SDH Reference Manual.
The community name is a form of authentication and access control. The community name
Note
assigned to the ONS 15310-MA SDH is case-sensitive and must match the community name
of the network management system (NMS).
UDP Port—The default User Datagram Protocol (UDP) port for SNMP is 162. (More information
about provisioning the UDP port is also given in the
page 18-23 and "DLP-H226 Set Up SNMP for an ENE" task on page
Trap Version—Choose either SNMPv1 or SNMPv2. Refer to your NMS documentation to determine
whether to use SNMP v1 or v2.
Chapter 3
at the node where you want to set up SNMP.
"DLP-H225 Set Up SNMP for a GNE" task on
18-24.
Turn Up a Node
78-19416-01