Using Static Ip Addresses - Cisco ONS 15310-MA SDH Procedure Manual

Click Finish.
Step 14
Note
Return to your originating procedure (NTP).
Step 15
DLP-H23 Set Up a Windows PC for Craft Connection to an ONS 15310-MA SDH
on the Same Subnet Using Static IP Addresses
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Verify the operating system that is installed on your computer:
Step 1
a.
b.
c.
According to the Windows operating system installed on your computer, perform one of the following
Step 2
steps:
•
•
•
•
•
•
If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
Step 3
configuration:
a.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-32
Be sure to record the names of the directories you choose for JRE and the online user manuals.
This task sets up your computer for a local craft connection to the
ONS 15310-MA SDH when:
•
•
None
NTP-H13 Set Up Computer for CTC, page 2-1
As needed
Onsite
None
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel window, double-click the System icon.
On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP (Windows Vista
and Window 7 for Release 9.2).
For Windows 98, complete
For Windows NT 4.0, complete
For Windows 2000, complete
For Windows XP, complete
For Windows Vista (Release 9.2), complete
For Windows 7 (Release 9.2, complete
From the Windows Start menu, choose Settings > Control Panel.
You will connect to one ONS 15310-MA SDH; if you will connect to
multiple nodes, you might need to reconfigure your computer's IP
settings each time you connect to a node.
You need to use non-ONS 5310-MA SDH applications such as ping
and tracert (trace route).
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Chapter 16 DLPs H1 to H99
78-19416-01