Dlp-H171 Apply A Lock-On - Cisco ONS 15310-MA SDH Procedure Manual

Manually set the node name and network configuration to site-specific values. See the
Step 8
Up Name, Date, Time, and Contact Information" procedure on page 3-3
Date, Time, and Contact Information" procedure on page 3-3
IP address, subnet mask and gateway, and IIOP port.
Return to your originating procedure (NTP).
Step 9

DLP-H171 Apply a Lock-on

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For a 1+1 optical protection group, only the working port can be placed in the lock on state.
Note
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group where you want to apply a lock on.
Step 2
If you determine that the protect port is in standby mode and you want to apply the lock on to the protect
Step 3
port, make the protect port active:
a.
b.
Step 4 In the Selected Group list, click the active port where you want to lock traffic.
Step 5 In the Inhibit Switching area, click Lock On.
Step 6 Click Yes in the confirmation dialog box.
The lock-on has been applied and traffic cannot be switched to the working port. To clear the lock on,
see the
Step 7 Return to your originating procedure (NTP).
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-64
This task prevents traffic from being switched from one port to another.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Maintenance or higher
In the Selected Group list, click the protect port.
In the Switch Commands area, click Force.
"DLP-H173 Clear a Lock-on or Lockout" task on page
Chapter 17 DLPs H100 to H199
"NTP-H20 Set
and "NTP-H20 Set Up Name,
for information on setting the node name,
17-65.
78-19416-01