Cisco ONS 15310-MA SDH Procedure Manual page 411

Chapter 17 DLPs H100 to H199
In the POS Ports Create Threshold window, the variables that appear in the Variable drop-down list
depend on the framing mode used by the cards. The two framing modes for the POS port on the
CE-Series and ML-Series cards are HDLC (High-Level Data Link Control) and GFP-F (frame-mapped
generic framing procedure).
Table 17-1
Table 17-1
Variable
iflnOctets
iflnUcastPkts
ifInMulticastPkts
ifInBroadcastPkts
ifInDiscards
iflnErrors
ifOutOctets
ifOutUcastPkts
ifOutMulticastPkts
ifOutBroadcastPkts
txTotalPkts
rxTotalPkts
dot3statsAlignmentErrors
dot3StatsFCSErrors
dot3StatsSingleCollisionFrames
etherStatsUndersizePkts
etherStatsFragments
etherStatsPkts64Octets
etherStatsPkts65to127Octets
78-19416-01
provides a list of the Ether ports threshold variables available in this field.
Ethernet Threshold Variables (MIBs)
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Definition
Total number of octets received on the interface, including
framing octets
Total number of unicast packets delivered to an appropriate
protocol
Number of multicast frames received error free
The number of packets, delivered by this sublayer to a higher
(sub)layer, which were addressed to a broadcast address at this
sublayer
The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol
Number of inbound packets discarded because they contain
errors
Total number of transmitted octets, including framing packets
Total number of unicast packets requested to transmit to a single
address
Number of multicast frames transmitted error free
The total number of packets that higher-level protocols requested
be transmitted, and which were addressed to a broadcast address
at this sublayer, including those that were discarded or not sent
Total number of transmit packets
Total number of receive packets
Number of frames with an alignment error, that is, frames with a
length that is not an integral number of octets and where the
frame cannot pass the frame check sequence (FCS) test
Number of frames with framecheck errors, that is, where there is
an integral number of octets, but an incorrect FCS
Number of successfully transmitted frames that had exactly one
collision
Number of packets received with a length less than 64 octets
Total number of packets that are not an integral number of octets
or have a bad FCS, and that are less than 64 octets long
Total number of packets received (including error packets) that
were 64 octets in length
Total number of packets received (including error packets) that
were 65 to 172 octets in length
17-5