Dlp-H277 Create User Defined Alarm Types; Dlp-H278 Configure Link Integrity Timer - Cisco ONS 15310-MA SDH Procedure Manual

Return to your originating procedure (NTP).
Step 3

DLP-H277 Create User Defined Alarm Types

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The alarms and controls are provisioned using the 15310E-CTX-K9 card view. For information about
Note
the 15310E-CTX-K9 external alarms and controls, virtual wire, and orderwire, refer to the
Cisco ONS 15310-MA SDH Reference Manual.
In the node view, double-click the active 15310E-CTX-K9 card. The card view appears.
Step 1
Click the Provisioning > External Alarms > User Defined Alarms tabs.
Step 2
Click Add. The Enter New Alarm Type dialog box will display.
Step 3
In the name field type the new alarm type name and click OK.
Step 4
•
•
Click the External Alarms tab.
Step 5
Verify that the defined name appears in the Alarm Type drop-down list.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-H278 Configure Link Integrity Timer

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-76
netsh interface tcp set global autotuninglevel=disabled
Autotuning can be enabled if desired using the following command:
netsh interface tcp set global autotuninglevel=normal
This task creates alarm types for external alarms on the 15310E-CTX-K9.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
The name can be up to 20 alphanumeric characters (upper case). No spaces, no special characters,
hyphen (-) is allowed.
Up to 50 different Alarm Types can be defined.
This task sets the link integrity soak timer for each port in the Ethernet card
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01