Dlp-H208 Create An Ip-Over-Clns Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

•
•
•
•
Click OK.
Step 4
Step 5 Return to your originating procedure (NTP).

DLP-H208 Create an IP-Over-CLNS Tunnel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution IP-over-CLNS tunnels require two end points. You will create one point on an ONS 15310-MA SDH.
The other end point is generally provisioned on non-ONS equipment including routers and other vendor
NEs. Before you begin, verify that you have the capability to create an IP-over-CLNS tunnel on the other
equipment location.
In node view, click the Provisioning > OSI > Tunnels tabs.
Step 1
Click Create.
Step 2
In the Create IP Over CLNS Tunnel dialog box, complete the following fields:
Step 3
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-8
ISH—Sets the Intermediate System Hello PDU propagation frequency. Intermediate system NEs
send ISHs to other ESs and ISs to inform them about the unlocked NETs it serves. The default is
10 seconds. The range is 10 to 1000 seconds.
IIH—Sets the Intermediate System to Intermediate System Hello PDU propagation frequency. The
IS-IS Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The
range is 1 to 600 seconds.
IS-IS Cost—Sets the cost for sending packets on the LAN subnet. The IS-IS protocol uses the cost
to calculate the shortest routing path. The default IS-IS cost for LAN subnets is 20. It normally
should not be changed.
DIS Priority—Sets the designated intermediate system (DIS) priority. In IS-IS networks, one router
is elected to serve as the DIS (LAN subnets only). Cisco router DIS priority is 64. For the
ONS 15310-MA SDH LAN subnet, the default DIS priority is 63. It normally should not be
changed.
This task creates an IP-over-CLNS tunnel to allow ONS 15310-MA SDH
nodes to communicate across equipment and networks that use the OSI
protocol stack.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Tunnel Type—Choose a tunnel type:
Cisco—Creates the proprietary Cisco IP tunnel. Cisco IP tunnels add the CLNS header to the
–
IP packets.
GRE—Creates a Generic Routing Encapsulation tunnel. GRE tunnels add the CLNS header and
–
a GRE header to the IP packets.
Chapter 18 DLPs H200 to H299
78-19416-01