Dlp-H24 Set Up A Windows Pc For Craft Connection To Ons 15310-Ma Sdh Using Dynamic Host Configuration Protocol - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
If you have Windows 7 installed on your PC (Release 9.2 only), complete the following steps to change
Step 8
its TCP/IP configuration:
a.
b.
c.
d.
e.
f.
g.
h.
i.
Step 9 Return to your originating procedure (NTP).
DLP-H24 Set Up a Windows PC for Craft Connection to ONS 15310-MA SDH
Using Dynamic Host Configuration Protocol
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not use this task for initial node turn-up. Use the task only if DHCP forwarding is enabled on the
Caution
ONS 15310-MA SDH. By default, DHCP is not enabled. To enable it, see the
Network Access" procedure on page
The ONS 15310-MA SDH does not provide the IP addresses. If DHCP forwarding is enabled, it passes
Note
DCHP requests to an external DHCP server.
Verify the operating system that is installed on your computer:
Step 1
a.
b.
78-19416-01
From the Windows Start menu, choose Control Panel.
In the search box, type adapter, then under Network and Sharing Center, click View Network
Connections.
Right-click the Local Area Connection icon, then click Properties.
Click the Networking tab. Under This connection uses the following items, click Internet
Protocol Version 4 (TCP/IPv4), then click Properties.
Click Use the following IP address, then in the IP Address field, enter an IP address that is identical
to the ONS 15454 IP address shown on the ONS 15454 LCD except for the last octet. The last octet
must be 1 or 3 through 254.
In the Subnet Mask field, type 255.255.255.0.
In the Default Gateway field, type the ONS 15454 IP address.
Click OK.
In the Local Area Connection Properties dialog box, click OK.
This task sets up your computer for craft connection to the
ONS 15310-MA SDH using DHCP.
None
NTP-H13 Set Up Computer for CTC, page 2-1
NTP-H21 Set Up CTC Network Access, page 3-6
As needed
Onsite
None
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel window, double-click the System icon.
3-6.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"NTP-H21 Set Up CTC
16-35