Dlp-H102 View Ether Ports And Pos Ports Utilization Pm Parameters - Cisco ONS 15310-MA SDH Procedure Manual

In node view, double-click a CE-Series or ML-Series Ethernet card. The card view appears.
Step 1
Click the Performance > Ether Ports > Statistics tabs or the Performance > POS Ports > Statistics
Step 2
tabs.
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 3
The PM parameter names appear on the left side of the window in the Param column. The parameter
numbers appear on the right side of the window in the Port # columns. For PM parameter definitions,
refer to the "Performance Monitoring" chapter in the Cisco ONS 15310-MA SDH Reference Manual.
View the Port # columns to see the current PM statistics for each port.
Step 4
Return to your originating procedure (NTP).
Step 5

DLP-H102 View Ether Ports and POS Ports Utilization PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click a CE-Series or ML-Series Ethernet card. The card view appears.
Step 1
Click the Performance > Ether Ports > Utilization tabs or the Performance > POS Ports > Utilization
Step 2
tabs.
Click Refresh. Performance monitoring utilization values for each port on the card appear.
Step 3
View the Port # column to find the port you want to monitor.
Step 4
View the Prev-n columns to find Tx and Rx bandwidth utilization values for the previous time intervals.
Step 5
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-2
This task enables you to view line utilization PM counts on a CE-Series
or an ML-Series Ethernet card and port to detect possible performance
problems.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Chapter 17 DLPs H100 to H199
78-19416-01