Dlp-H13 Install Lfh Cables For Ons 15310-Ma Sdh E1 Connections - Cisco ONS 15310-MA SDH Procedure Manual

Return to your originating procedure (NTP).
Step 3

DLP-H13 Install LFH Cables for ONS 15310-MA SDH E1 Connections

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
Prepare a 96-pin LFH connector terminated to a 21-pair #26 AWG cable.
Step 1
See
Step 2
Note
Table 16-4
Transmit Cable Signal
Pin Connection
1 TX11-
2 TX11+
3 TX10-
4 TX10+
5 TX9-
6 TX9+
7 TX8-
8 TX8+
9 TX7-
10 TX7+
11 TX6-
12 TX6+
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-14
This task installs E1 cables on the ONS 15310-MA SDH.
96-pin LFH connector terminated to a 21-pair #26 AWG cable
NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin
Connections, page 1-26
As needed
Onsite
None
Guide.
Table 16-4 for the ONS 15310-MA SDH connector pin assignments.
Refer to the "Cisco ONS 15310-MA SDH Hardware" chapter in the Cisco ONS 15310-MA SDH
Reference Manual for specific information on E1 cables and E1 connectors, including product
numbers and compatibility.
E1 Connector Pin Assignments
Conductor Color Pin
blue-black 49
black-blue 50
gray-red 51
red-gray 52
brown-red 53
red-brown 54
green-red 55
red-green 56
orange-red 57
red-orange 58
blue-red 59
red-blue 60
Receive Cable Signal
Connection Conductor Color
TX21- blue-violet
TX21+ violet-blue
TX20- gray-yellow
TX20+ yellow-gray
TX19- brown-yellow
TX19+ yellow-brown
TX18- green-yellow
TX18+ yellow-green
TX17- orange-yellow
TX17+ yellow-orange
TX16- blue-yellow
TX16+ yellow-blue
Chapter 16 DLPs H1 to H99
Cisco ONS Electrostatic Discharge
78-19416-01